Learn how to prime Berkey filters to get your water flowing quickly. Here’s a step by step guide to get you going.
Our family loves our Berkey water filter. We use it to filter out things we don’t want to be drinking from our well water. It filters out water for all of my real food, homemade recipes, water for my sourdough starter, and obviously, water for drinking. The ONLY change I would make if I could go back in time, is I would buy the biggest Berkey available, the big Berkey.
You don’t need to have a well to enjoy a Berkey water filter though. If you live in a city, you can be certain that your water is full of stuff that you don’t want to be drinking. We don’t need a flouride filter here but if you live in the city, I would suggest using Berkey’s arsenic/flouride filter.
As a mother, you are working hard to give your family the nutrients they need to grow. If water is the most important thing, you need to be sure that you are giving yourself and your family clean water.
Personally, we test our water once a year. Three different tests at the same time actually. Once with straight well water, one with water from our reverse osmosis, and then one through the Berkey filter. Every year, the Berkey shows us that the money we spent on it was well worth it.
Today, I’m going to show you how to prime the filters.
Why do I Need to Prime Berkey Filters?
When you first get your new Berkey water filter, priming is part of the setup process. If you don’t prime the filters, they won’t filter the water. Perhaps they will, but it will take a long time. Priming is just forcing water through the filter to get the air our of the filters.
However, maybe you have had a Berkey water filter for awhile now and notice that the flow rate has slowed way down. This is telling you that it’s time to prime again.
Priming is something that you have to do if you own a Berkey water filter.
How to Prime Berkey Filters
When you got your Berkey filter, it came with a thick tan washer. However, if you have lost it, you can get another one through Berkey. This washer funnels water into the filters. It’s important.
- First, if you already are using your Berkey, you will need to take the filters out of the system.
- Next, put the tan priming button onto the black Berkey filter. Place it on the tube where the water will be coming out of once it’s put together.
- Turn your water on to your sink. Put it on low though because otherwise water will squirt everywhere.
- Place the stem of the filter with the priming piece firmly up to your faucet. Allow the water to fill up the inside of your filter. It should slowly start to feel heavier and eventually water should start seeping out of it in little sweat beads.
- Allow those sweat beads to show for about 10-20 seconds.
- Congratulations! You have successfully primed your Berkey water filter! It could have taken up to 4 or 5 minutes.
- Repeat on other filters.
Did I Prime the Filters Correctly?
Assuming that you had the sweat beads on every filter, you should have primed them correctly. When you put your Berkey together, you will know for sure by the pace at which the water flows.
After I prime my filters, I like to run the red dye test to be sure that the filters are working properly.
This post contains affiliate links, which means I make a small commission at no extra cost to you. See my full disclosure here.